bgrorud

Change Replication Monitoring Interval to Multiple Days

I would like to figure out how to extend the period of time that my Hyper-V replication collects statistics for. I would like to extend it to cover multiple days so I have a better picture of the mx / average size of replication data before extending it
over a WAN connection.  I found the following powershell command -

Set-VMReplicationServer -MonitoringStartTime 06:00:00 -MonitoringInterval 12:00:00

Which says I should be able to extend the interval by up to 7 days.  However, I cannot figure out what format I need to type in the numbers to make it monitor more than 1 day. If I try to put in 96:00:00 I get the following error -

Set-VMReplicationServer : A parameter is invalid. Value for the monitoring interval is not valid. The value must be an
even fraction (in hours) of a 24-hour day or whole days. The valid range is 1 hour to 7 days.
At line:1 char:1
+ Set-VMReplicationServer -MonitoringStartTime 06:00:00 -MonitoringInterval 96:00: …
+ ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
    + CategoryInfo          : InvalidArgument: (:) [Set-VMReplicationServer], VirtualizationInvalidArgumentException
    + FullyQualifiedErrorId : InvalidParameter,Microsoft.HyperV.PowerShell.Commands.SetReplicationServerCommand

WAIT!  I just found the answer, but I’m still going to post the question in case other people have this same issue.  The format for the interval to put in is DAYS.00:00:00, so in my case, I put in 6.00:00:00 and it took it, so hopefully it will
work.  I’ll check back in a few days.

Thanks!

-Brad

Read full post . . . .

Go Que Newsroom Categories

Fatal error: Allowed memory size of 67108864 bytes exhausted (tried to allocate 36 bytes) in /home/content/36/8658336/html/goquecom/wp-includes/taxonomy.php on line 3613